CISCO SPA3102 MANUAL PDF

LAN port yellow will be used only during initial configuration. Configuring SPA The configuration information below is based on firmware version 5. Before we proceed, please make sure that your SPA is powered on and that you have an ethernet RJ45 cable connected with one end to your PC and the other end to the yellow port on the back of the SPA Default IP address of Linksys is Once you have verified this, please continue configuring your device with the instructions below. Click on WAN setup.

Author:Neshicage Brazragore
Country:Indonesia
Language:English (Spanish)
Genre:Science
Published (Last):3 September 2018
Pages:100
PDF File Size:15.83 Mb
ePub File Size:9.81 Mb
ISBN:792-2-47598-440-9
Downloads:78283
Price:Free* [*Free Regsitration Required]
Uploader:Sharr



The SPA is reliable and relatively inexpensive and can be considered by individuals who want the extra PSTN functionality for their specific environments.

You will also want to connect a regular telephone RJ11 cable to the phone port labeled "Phone". Once you have verified this please continue configuring your device with the instructions below. We recommend that you read each step through in its entirety before performing the action indicated in the step.

To do so have a pen and paper ready to write down the IP address. Please enter option followed by the pound key Write this number down Do not hang up yet. To enable web-based configuration: You will hear the menu prompt again after acquiring the IP address.

After hearing the prompt dial followed by 1 then 1 when asked to save the change. You should now have the IP address for your SPA as well as the ability to configure your device through your web browser. Continue onto Step 2 below. For example if you heard " If you are prompted for a username and password please enter the one you configured. Once logged in you should see a page such as the following: STEP 3 We now want advanced access to this device so that we may make the proper configuration changes.

First click on Admin login from the right side of the page, then click on Advanced: We are now ready to enter your Callcentric account information as well as properly configure your time and DNS servers. Continue to Step 4. Once done scroll to the bottom of the page and click on Submit All Changes to save your changes. Once the page reloads click on the Voice tab at the top of the page and go to Step 5.

You will be provided with the various low level SIP protocol and codec related options we will need to change in order to make sure your device is configured properly. STEP 6 This is the last configuration step of this guide. Here you will configure additional settings specific to your Callcentric account which will enable you to register your SPA to Callcentric.

GUJARATI NAGI VARTA PDF

Cisco SPA2102 Administration Manual

.

KRAMER VP-501XL PDF

Linksys SPA3102 ATA

.

IEEE 1044.1 PDF

SPA3102 manual?

.

BONFIGLIOLI GEARBOX CATALOGUE PDF

Cisco Systems PAP2T, SPA2102, WRP400, SPA3102, SPA8000 User Manual

.

Related Articles